VERTEX 10" RADIUS AND ANGLE DRESSER (3800-5227)
$1,188.81
In stock
SKU
3800-5227
.
- 10" Radius and Angle Dresser
- Positive setting of the diamond to absolute center with the special gauge included with the dresser.
- Simple, fast, accurate radius setting; no height gauge or other set-up aids required.
- Radius is set on the grinder by measuring over the two pins or by inserting a gauge block, as shown, for direct reading.
- Inside or outside radius is determined simply by sliding the dowel pin to the right for concave and to the left for convex.
- 4 X 90 Degree graduation in full 360 degree circle.
- 6 minute vernier reading.
- One push-pull type knob for radius and angle control and for safer and faster operations.
- Extremely close tolerances are held in the manufacture of this tool, assured by hardening and precision grinding of all critical parts.
- Ways are chrome hardened.
- Set-up & dressing time reduced to a bare minimum due to simplicity.
- Maximum diameter of the wheel is 10" ~ Maximum wheel extending diameter is 14.8"
- Convex range is 0.8R-40R ~ Concave range is 0-40R
- Overall length is 13" ~ Overall height is 6.3" ~ Weighs 26 lbs.
- Vertex # V-TDB
- Shipping Weight: 26 lbs
Catalog Page # | 317 |
---|
Write Your Own Review